产品特性 颐兴ES-06“好好涂”柔韧性聚合物水泥防水胶,是采用优质建筑专用聚合物防水胶乳为主要原料,以多种助剂配制而成的 防水胶乳。用该胶乳与水泥混合后,涂刷于基面上,可形成具 有一定的弹性、粘结力强、抗弯强度高、抗渗性、 抗裂性、耐候性、耐酸碱性优异的 柔韧性防水层,该产品无毒、无污染,施工简便,完全符合环保要求。
Product features ES-06“Nice-Coat” Flexible Polymer Cement Waterproof Glue is waterproof latex formed with quality dedicated building polymer waterproof latex as main material, together with several auxiliary agents. Using this latex to mix with cementbrush applying to base surface can form a flexible waterproof layer with certain elasticity, high bonding strength, high bending strength as well as excellent anti- permeability, crack-resistance, weather-resistanceacid/alkali-resistance. This product is non-toxic, pollution-free, easy to use, fully meeting environmental protection requirements.
适用范围 ◆ 外墙、屋面、厕浴间、厨房、水池、 ◆ 地下室及建筑物各部分的防水、防渗、防潮; ◆ 用于加气混凝土、 ◆ 空心砖等多孔砌体材料的防渗漏、防潮。
Application range ◆ Exterior wall, roof, bathroom, kitchen, pool, basement ◆ different parts of a building for waterproofing, seepage-proofing, ◆moisture-proofing; used for seepage-proofing ◆ moisture-proofing of aerated concrete, air bricksuch ◆ porous building materials.
施工方案 ◆ 基面处理:基面要求平整、干净、湿润、坚实、无浮灰、无明水、 无油污。有蜂窝、 裂缝等缺陷的先要进行修补、阴阳角做成弧形; 过分干燥基面必须洒水湿润后才能施工。 ◆ 防水胶的配制:水泥=1:0.8的重量比配制好,用搅拌器搅拌至均匀细微,不含团粒 的混合物即可使用,配好的胶料使用 时间不宜超过30分钟。 ◆ 涂布施工:将配制好的防水胶均匀地涂刷在基面上,一般涂刷2-3遍, 达到设计 要求厚度,涂覆间隔以前一道 不粘手为宜,间隔时间约120分钟(视天气情况而定); 防水涂膜表干后方可进行下道工序的施工。 如要用淋水或蓄水验收, 防水涂膜必须干 固7天后方可进行。 ◆ 防水增强处理:可用无纺布作胎体增强。
Construction ◆ Base surface treatment: The base surface should be flat, clean, damp, solid, without dust, without waterwithout oil stain. Surface with honeycomb, cracksuch flaws should first be repaired; inside corners should be treated to be arc; surface too dry must be wetted with water before construction. ◆ Preparation of waterproof glue: cement =1:0.8 weight ratio; use mixer for mixing until evenfine compound without granule is achieved. The service time of the prepared glue should not exceed 30 minutes. ◆ Coatingconstruction: Brush apply the prepared waterproof glue evenly on the base surface, generally 2-3 times to achieve designed thickness. The interval between brush coatings is about 120 minutes, which is sui when the previous layer is not sticky (depending on the weather);the next process should not begin before surface dry of the waterproof coating. If water pouring water storage test is required, it must no be made until 7 days after drying and solidifying of the coating. ◆ Treatment for enhanced waterproofing: Non-woven fabrics can be used for body reinforment.
注意事项 ◆ 防水胶在使用时如过稠,可适量加水稀释; ◆ 使用水泥为32.5(R)以上普硅水泥; ◆ 使用前摇匀效果更好; ◆ 推荐用量:厚度1mm用量约1.0kg/m2 。
Notes ◆ If the waterproof glue is too thick, proper amount of water may be added for dilution; ◆ Ordinary Portland cement above 32.5 (R) is used; ◆ Shake before using for better effects; ◆ Recommended usage: thickness of 1mm, usage of 1.0kg/m2
包装规格 25kg/桶 50kg/桶 (备有家装型包装:2kg/罐、5kg/罐)。
Packaging specification 25kg/barrel 50kg/barrel (Also available in home decoration package: 2kg/can、5kg/can)
贮存期 存放在阴凉处,保质期为6个月。
Storage period Stored in cool place, with shelf life of 6 months.
安全事项 施工时须戴手套和护目镜。万一溅到皮肤或眼睛,须用清水冲洗。如有发炎现象, 须就医。 干粉操作须小心以减少形成粉尘。如果粉尘很多,须戴可见面罩。
|